DECOMPRESSION EXHAUST VALVE LEVER ARM, O.H.V. SINGLES

FITS SOME SIDE VALVE ENGINES. SEE PICTURES AND DIMENSIONS. 
SPINDLE BORE: 1/2" (12.6MM)
OFFSET: 1 1/8" (29MM) - MEASURED FROM CENTRE OF BOLT HOLE TO CENTRE OF CABLE HOLE)
LENGTH: 1 3/8" (35MM) - MEASURED FROM CENTRE OF SHAFT HOLE TO CENTRE OF CABLE HOLE)

NOT ALL SIDE VALVES ARE THE SAME, THIS ARM FITS THE ENGINES WHERE THE SPINDLE POINTS FORWARDS BENEATH THE EXHAUST PORT.
ONE OF A RANGE OF 3 CLUTCH OPERATING AND DECOMPRESSION LEVER ARMS WE HAVE HAD MADE.  TOP QUALITY FORGINGS, HEAT TREATED AND TEMPERED.  NEW FORGING TOOLS ALLOWED US TO CLEAN UP THIS COMPONENT CONSIDERABLY, REMOVING UNWANTED MATERIAL AND FLASHING'S ETC.  THEY ARE THEN POLISHED AND SENT TO A WELL KNOWN UK GUNSMITH FOR GUN BLACKING, AN ATTRACTIVE CHEMICAL PROCESS.  SUPPLIED WITH A STAINLESS STEEL PINCH BOLT.

THE FULL RANGE IS A2/67, D12/377 AND A2/377.