OPERATING LEVER ARM

OPERATING LEVER ARM

SEE PICTURES AND DIMENSIONS.
SPINDLE BORE: 1/2" (12.6MM)
OFFSET: 1/2" (12.6MM) - MEASURED FROM CENTRE OF BOLT HOLE TO CENTRE OF CABLE HOLE
LENGTH: 1 3/4" (45MM) - MEASURED FROM CENTRE OF SHAFT HOLE TO CENTRE OF CABLE HOLE

VERY SIMILAR TO A2/377 CLUTCH OPERATING ARM BUT LESS OFFSET AND THE CABLE SLOT FOR THIS ARM IS IN LINE WITH THE CENTRE OF THE ARM WHILST A2/377 HAS THE CABLE SLOT AT 90 DEGREES TO THE SPINDLE BORE.

ONE OF A RANGE OF 4 CLUTCH OPERATING AND DECOMPRESSION LEVER ARMS WE HAVE HAD MADE.  TOP QUALITY FORGINGS, HEAT TREATED AND TEMPERED.  NEW FORGING TOOLS ALLOWED US TO CLEAN UP THIS COMPONENT CONSIDERABLY, REMOVING UNWANTED MATERIAL AND FLASHING'S ETC.  THEY ARE THEN POLISHED AND SENT TO A WELL KNOWN GUNSMITH FOR GUN BLACKING, AN ATTRACTIVE CHEMICAL PROCESS.  

SUPPLIED WITH A STAINLESS STEEL PINCH BOLT.

THE FULL RANGE IS: A2/67, D12/377 AND A2/377